cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
529
Views
5
Helpful
3
Replies

AIR-AP1832I-K-K9 no power supply with AIR-PWRINJ6

JunHeng
Beginner
Beginner

My AP (AIR-AP1832I-K-K9) can be turn on with PoE but not the Power Injector (AIR-PWRINJ6).

 

If anyone please can help me with my case then it will be highly appreciable.

 

Thank you,

 

Regards,

 

JunHeng

3 Replies 3

Kasun Bandara
VIP Advocate VIP Advocate
VIP Advocate

Hi,

 

according to datasheet,

https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1830-series-access-points/datasheet-c78-735582.html

this support both J5 and J6 injectors with conditions. better check device with another power injector because port may be faulty. also make sure you are connecting to correct power in-out ports to AP and switch. also check power source connected to injector.

 

rate this and mark as answer, if this solved your issue

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Hi Kasun,

Thanks for replying,

I’ve tried different APs with the same injector, they all works, it’s just this AP has some power issues. The injector is working well.

Thank you, Regards,

 

JunHeng

 

 

Hi,

 

in that case, better open TAC and request for replace.

 

rate this and mark as answer, if this helps

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: