Dear community, I have an AP 1542 outdoor and wlc 3504. The Ap can't join the controller. I keep on getting this error. On the GUI i see radius authorization of the ap has failed. But no Ap policies is enabled! [*10/22/2021 14:09:42.0499] GOING BAC...
Hi guys,We have a customer with 2600, 2700, 2800 APs and we're migrating a customer to 9115, 9120 and 9130.They have a pair of 5520 running 8.10.142The customer's switch ports are configured with dot1x and mab authentication. The ports are configured...
I have cisco ap2702i. I want one as a AP and second one as a Repeater. please guide how to configure AP as a repeater
Hello Cisco WLAN-experts,I would like to deactivate the heatmap for some of the shown WLAN APson one of my floors to check the signal for a new WLAN AP for example.See picture attached.But I cannot find this feature anymore on the new map representat...
For 9800 WLC, to have AP connect and provide a captive portal are these the part# required for DNA licenses? 1. DNA Essentials ----- AIR-DNA-E-3Y2. DNA Spaces ACT --- CISCODNAS-ACTIs there a part# for DNA cloud software itself? Thanks!
Hello Experts, AIR-ANT2566P4W-R for being having greater azimuth and elevation compared to AIR-ANT2566D4M-R should have comparatively larger coverage cell. However as the gain is same on these two antennas(6dBi), will using AIR-ANT2566D4M-R gives ...
I am trying to test this feature using both the ME 8.10.151 and the ap3g3-k9w8-tar.153-3.JPK2.tar. I have been following the guide for Wave2 APs here: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-10/config-guide/b_cg810/workgroup_bridg...
still fighting 1552e and is that normal? if not how can i enable it?ap#archive config Archive feature not enabled
wlc 8540 sw 8.10.151.0ap 2802i, 2702e
I have been using Fluidmesh for 15 years, but recently bought some new kit, 8 x Volos and 2 z 3200 radios. I cannot seem to be able to access the Fluidmesh Portal to add in my license plug ins, anyone any Ideas please?
Can any one say me Mikrotik router is compatible with Cisco AP? If it is possible then Which model is suitable? Actually I have some cisco AP and Mikrotik Router. I want use those AP with Mikrotik router. Please suggest possible solution asap. Thank ...
hi guyssomeone pls advise me that how to set up CISCO AP1142 to the controller(Cisco 5500)detailed information(command line, default log in information, etc) we need for setting up APspls share your knowledge
Is there a way to take a WLC 5508, enable peer-to-peer blocking functionality and send the traffic up stream to be ran through an ACL and then sent back down to the WLC 5508 back into the same WLAN? A switch typically won't forward traffic out the p...
Hello, I got a question when i read the Flexconnect group document (link is listed below). Please see the screenshot which is from this document. The interface g1/0/4 with trunk and native vlan are connected to a AP(flexconnect mode). Based on the in...
Hi, we would like to upgrade our Cisco prime from 3.4 to 3.9 and the documentation is quite vague on the process. can someone help me with the path please and things to consider? kind regards,Ali
