09-06-2017 10:30 PM - edited 07-05-2021 07:37 AM
I have such access point AIR-CAP2702E-S-K9"
Site
https://www.cisco.com/c/dam/assets/prod/wireless/wireless-compliance-tool/index.html
is showing that it is for Thailand.
Wireles controller is configured for Thailand
Access points AIR-CAP2702E-E-K9 working as expected, but for AIR-CAP2702E-S-K9 it disables 5GHz band
What is the problem?
Solved! Go to Solution.
10-09-2017 07:48 AM
I've just upgraded firmware on controller from 8.0.140 to 8.3.121 and now in "country" settings I can see access points type which are expected -E & -S
thanks.
09-06-2017 11:00 PM
Paste the output of these commands:
sh sysinfo from WLC
sh version from AP
Regards
Dont forget to arte helpful posts
09-06-2017 11:35 PM
(Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.140.7
Bootloader Version............................... 1.0.20
Field Recovery Image Version..................... 7.6.101.1
Firmware Version................................. FPGA 1.7, Env 1.8, USB console 2.2
Build Type....................................... DATA + WPS
System Name...................................... wlc01-ha
System Location.................................. IT room
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1069
Redundancy Mode.................................. SSO
IP Address....................................... 10.105.208.4
IPv6 Address..................................... ::
Last Reset....................................... Software reset
System Up Time................................... 17 days 6 hrs 28 mins 8 secs
System Timezone Location.........................
System Stats Realtime Interval................... 5
System Stats Normal Interval..................... 180
Configured Country............................... TH - Thailand
--More-- or (q)uit
Operating Environment............................ Commercial (0 to 40 C)
Internal Temp Alarm Limits....................... 0 to 65 C
Internal Temperature............................. +39 C
External Temperature............................. +24 C
Fan Status....................................... OK
State of 802.11b Network......................... Disabled
State of 802.11a Network......................... Enabled
Number of WLANs.................................. 4
Number of Active Clients......................... 100
Burned-in MAC Address............................ 00:9E:1E:E3:49:00
Power Supply 1................................... Present, OK
Power Supply 2................................... Absent
Maximum number of APs supported.................. 500
System Nas-Id....................................
WLC MIC Certificate Types........................ SHA1/SHA2
--------------------------------
sh version from access point cannot get as it was removed. It joinde controller, controller identified it as Thailand region but did not enable 2.4/5 Ghz interfaces (they in down state)
We've tried in another controller, it behaived the same.
06-07-2018 08:04 PM
my country (yemen) is not list in the WLC what can i do
06-07-2018 09:58 PM
Ask to your supplier about it. He may help you.
Regards
Dont forget to rate helpful posts
09-06-2017 11:02 PM
09-06-2017 11:36 PM
only one regulatory domain is configured on wireless controller - TH
09-07-2017 12:08 AM
09-07-2017 12:42 AM - edited 09-07-2017 12:43 AM
this seems the cause,
how can I add support for -S regulatory domain?
I usually adding respective country, for this case some other settings should be applied?!
10-09-2017 07:48 AM
10-09-2017 10:01 AM
Hello everyone.
Can i ask someone how to configure AIR-AP1832I-E-K9 Ligthweigth to autonomous.
10-09-2017 12:48 PM
@rsantiago111 wrote:
Can i ask someone how to configure AIR-AP1832I-E-K9 Ligthweigth to autonomous.
1800/2800/3800 no longer support autonomous IOS. Autonomous AP concept has been replaced with Cisco Mobility Express where the AP is turned into an independent WLC while acting as an AP too.
10-09-2017 11:40 PM
10-09-2017 11:44 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide