AIR-CAP3702I-E-K9 autonomous firmware, SSID is always hidden

[Ha Dao]

Hi guys

I configure an AP: AIR-CAP3702I-E-K9 with autonomous firmware, but somehow I never seen the SSID name. It look like in Hidden mode (I still can connect my SSID by Hidden Network on win 10). How can I make it available ? 

You can see the blue SSID is empty name, I am sure that is from my AP I configuring.

[marce1000]

 - Check WLAN parameters for the particular SSID in the GUI of the ap-management , or use another SSID for the WLAN as an (example) sanity check.

 M.

[Rich R]

dot11 ssid SSID-NAME
vlan XX
authentication ......
mbssid guest-mode     <- This enables broadcast of the SSID

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3-JB/configuration/guide/cg_book/cg-chap7-mbssid.html

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap7-mbssid.html

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/service-set-identifier-ssid/210516-SSIDs-and-VLANs-configuration-on-Autonom.html

[Ha Dao · Accepted solution]

I miss this command, it work now, thank

dot11 ssid TEST

guest-mode