09-23-2020 10:17 AM - edited 07-05-2021 12:33 PM
Hi all,
Can you please tell me the CLI command to check what is the SFP model connected to the WLC. The WLC model is
AIR-CT7510-K9.
09-23-2020 11:30 AM
Try below command
show inventory raw | in SFP-
https://mrncciew.com/2014/08/18/wlc-sfp-info/
HTH
Rasika
*** Pls rate all useful responses ***
09-23-2020 07:53 PM
I tried this. I don't get any result
(Cisco Controller) >show inventory raw | in SFP-
Incorrect input! Use 'inventory'
(Cisco Controller) >
09-23-2020 08:11 PM
Sorry, I read it as 5760.
If it is AireOS, you can try the below command. Refer that blog post
(Cisco Controller) >debug fastpath cfgtool --dump.sfp
HTH
Rasika
*** Pls rate all useful rate ***
09-23-2020 09:44 PM
(Cisco Controller) >
(Cisco Controller) >debug fastpath cfgtool --dump.sfp
(Cisco Controller) >FP0.
FP0.
Port SFP Vendor Transceiver Type OUI PartNumber Rev SerialNumber DateCode Auth
1 Not Present (0x00)NOT_SUPPORTED fail
2 Not Present (0x00)NOT_SUPPORTED fail
(Cisco Controller) >
(Cisco Controller) >
I get this above result.. does it mean there is no SFP here? this is a 7510 model and sfp ports.
09-24-2020 08:24 AM
Could also mean it's not a Cisco SFP. If you can go on-site and you have an active LAG / Etherchannel, you might simply unplug one and check it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide