08-09-2018 06:39 AM - edited 07-05-2021 08:58 AM
Hi,
I have a AIR-SAP2602I-C-K9 which is not showing the 2.4GHz radio in the GUI configuration.When I configure dot11radio 0 on cli (which I assume is the 2.4GHz radio) it still does not work at 2.4GHz.
The AP is working fine for 5GHz.Find attached.
Please assist
08-09-2018 01:44 PM
Pls provide below CLI ouput
1. show interface summary
2. show run int d0
3. show run int d1
4. show controllers dot11Radio 0
HTH
Rasika
08-10-2018 12:22 AM
08-10-2018 03:28 AM
08-10-2018 04:32 AM
Hi
The dot11Radio 1 is also showing 5GHz. How does it occur for dot11Radio 0 to be 5GHz? Are these radios changeable?
08-10-2018 05:55 AM
the 2800/3800 series do have an option to enable two 5GHz radio's
but you specify the 2600 series..... afaik this model can't.
when you access the web-interface of the device what does this tell you?
is it possible to do a reset-to factory-defaults? and start from scratch?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide