cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1771
Views
0
Helpful
5
Replies

AP 1572 not booting

james8
Level 1
Level 1

Hello folks,

We have an AP 1572eac, that is not booting. When we connect the power 4 leds start do blinking simultaneously, and the AP do not boot, no console, no rommon. What's strange that if we let the AP powered off for some time, after that the AP boot for a while but after some time back to the original condition 4 leds start to blinking.

Any idea?

 

Thanks in advaced

1 Accepted Solution

Accepted Solutions

Rich R
VIP
VIP
5 Replies 5

Is there any log information or screenshots?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

Hello Rps,

 

Unfortunately, I am not able to get the logs, as I said It boot for few time. I´ve added the console info, that I could take before it locks again and starts do blinking all four leds. 

I see that the AP seems to be restarting in a loop.

40MB format
Cyprus MB -- 40MB of flash
Initializing flashfs...

......
40MB format
Cyprus MB -- 40MB of flash
Initializing flashfs...

IOS Bootloader - Starting system.
flash is writable
40MB format
Cyprus MB -- 40MB of flash
Xmodem file system is available.

Maybe you can try to reset, or enter ROMMON to upgrade the AP, otherwise, it is recommended to open TAC CASE, this AP may be replaced by RMA.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

Rich R
VIP
VIP

Hello guys, 

 

Making more tests, the problem is the internal power supply from the AP. Using the power injector works fine. So RMA needs do be done.

 

Thanks

Review Cisco Networking products for a $25 gift card