11-15-2012 06:35 AM - edited 07-03-2021 11:03 PM
A customer runs a 5508 WLC for quit a while. several dozens AP's are spread all over Europe an run just fine. All the AP's have a VPN based connection over an MPLS service provider, so we are using 10.x.x.x addresses only.
We have upgraded to release 7.2.111.3 to support OEAP 600 and we have configured NAT in the Firewall as well a policy to support the home office AP.
Everything works fine until the switch where the WLC was attached to crushed.
From this moment on, all internal AP's ar no longer able to register at the WLC.
A log at the console port on an AP shows that it tries to access the external (NAT) IP address.
We had to remove the NAT flag to support the internal AP's.
What to do now?
11-15-2012 06:46 AM
Have you tried entering this command via the cli?
config network ap-discovery nat-ip-only disable
Sent from Cisco Technical Support iPhone App
11-15-2012 02:52 PM
Hi, what version are the APs, see the sh ver, is not the IOS, Cisco has a problem with APs version 2 and 3 maybe you need to change those APs
Sent from Cisco Technical Support iPhone App
06-04-2013 02:35 AM
We are facing the exact same problem running 7.4.100.60 on the 5508.
One branch AP is connecting over Internet instead of the MPLS WAN link.
Have you found a solution to this problem?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide