I have an AIR-AP-1041N-A-K9
I'm trying to setup the AP for wireless networking.
As soon as I use a static IP (which I must), I can't connect to the AP at all. Not even using a web browser.
Making it simple, I open Putty and connect using the console cable. All I do is change the BVI1 IP address to a static IP.
- If I can connect via a web page, it would be a step in the right direction.
But as soon as I use a static IP, I am unable to connect to the unit via web.
Note: If I start the unit up and connect it to DHCP, the unit works fine. I can connect to it via web and all is good.
But I can't use DHCP on my network.
Any assistance would be greatly appreciated.
Thank You.
Rick.
