AP Login Credentials on 9800

[Wes Schochet]

I have a 2802 AP that is associated to a 9800 controller.  I am trying to log in to the AP, but get the message:

No valid user found, please configure a valid user from Controller

I cannot find this setting anywhere in the controller. (Of course, I know where it is on AirOS!)  A little help please!

Thanks

[balaji.bandi]

You Login to Administration to AP ? when the WLC Mnaging the AP, you can not Login to AP - or you trying something else ?

[ilay · Accepted solution]

You need to determine which Policy Tag your ap uses.

on "Monitoring-->Wireless--> AP Statistics" check "AP Profile" section

config on WEBUI:(It is better to use ssh, some models do not support telnet)

config on CLI:

---------Omit part of the output--------
ap profile default-ap-profile         <--- default ap profile 
description "default ap profile"
mgmtuser username admin password 0 Abc@1234 secret 0 Abc@1234
ap profile EWC-AP-Join-Profile        <--- customized ap profile
description "EWC-AP-Join-Profile"
mgmtuser username admin password 0 Abc@1234 secret 0 Abc@1234
ssh
ap a488.eeee.788c
policy-tag EWC_Policy_Tag
rf-tag EWC-RF-TAG
end

[Wes Schochet]

Thanks!

[Scott Fella]

Wes,

Did ilay answer your question?  If so, can you mark the post as the solution.