cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1275
Views
0
Helpful
5
Replies

AP unable to join WLC : MAC Address Problem?

craig-allen
Level 1
Level 1

I have an 1031 AP in a remote office which can't join the controller in the HQ. I'm using DNS for WLC discovery and have both the LWAPP + CAPWAP DNS entries configured. AP has static IP + DNS.

Basically the AP resolves the DNS name then connects to the WLC but then the WLC resets the connection.

I've observed the following in the system log:

Here I have the Manager & AP-Manager gateway pointing to the HSRP virtual address on my two 6509 core switches:

*May 27 16:25:44.728: %SIM-3-GW_MISMATCH: sim.c:1018 MAC address of the GW 00:21:56:93:08:00 recieved in the JOIN Request differs from the cached MAC addr 00:00:0c:07:ac:63 of the Gw. Deleting the Gw IP 10.200.1.252 for the AP Mgr & sending

Here' I changed to the gateway to point to the IP on the VLAN SVI interface.

*May 27 16:29:28.338: %SIM-3-GW_MISMATCH: sim.c:1018 MAC address of the GW 00:21:56:93:08:00 recieved in the JOIN Request differs from the cached MAC addr 00:21:a1:23:08:00 of the Gw. Deleting the Gw IP 10.200.1.254 for the AP Mgr & sending

A point to note is that the 00:21 MAC address is the internal L3 router within the 6509.

Network summary:

HQ network is 2 x 6509 running HSRP.

WLC 4404 with LAG into Core 1 switch running 5.2 (can't rember the exact revision)

100Mb WAN link into MPLS cloud, router is also connected to Core 1

Remote office is a DS3 with 3750 switch.

5 Replies 5

Rob Huffman
Hall of Fame
Hall of Fame

Hi Craig,

I think you are seeing this 5.x (and beyond) restriction

Controller  software release 5.0.148.0 or later is not compatible with Cisco  Aironet 1000 series access points.

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn52.html

Cheers!

Rob

My mistake it's a AIR-AP1131AG-A-K9 access point

Craig,

Playing back to basics...

1) No FW between your controller and the remote office?

2) Have you tried putting a static address of the controller in the AP?

3) Are you using HREAP by chance?

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

can you post a show run no ap on your wlc ?

Here is how

http://www.my80211.com/home/2010/2/24/wlc-show-run-config-no-ap.html

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Leo Laohoo
Hall of Fame
Hall of Fame

Can you try to upgrade to 6.X?  My doctors have recommended that I stay away from 5.X because it might give me an anaphylactic shock. 

Review Cisco Networking for a $25 gift card