cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|
554
Views
0
Helpful
2
Replies

AP1200s, WPA, PEAP, ACS Setup

dspringer1177
Level 1
Level 1

Hi folks.

I'm setting up 60 AP1200s across our campus and want to implement WAP with PEAP. I have ACS-Windows setup to authenticate to AD (I think) and have had some success testing, but I'm not getting consistant results with authentication and no DHCP on that particular SSID/VLAN. I have two other SSIDs/VLANs setup which are working well, one for public access (fully open), and one with WEP-128 for VoIP (7920 handsets). Both of these WLANs pass traffic fine and clients get DHCP addresses for their respective VLANs.

I guess me real question is if there a guide that someone can point me to that can help me get this setup, or some pointers that you can offer? If need be I can start everything over from scratch, so don't hold back on those "erase and start like this..." answers.

Thanks! -Derrick

2 Replies 2

smalkeric
Level 6
Level 6

I don't think you will get a document for your specific requirement, but the following guide gives you an idea on how to configure each topic individually,

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo1200/accsspts/bu12213/b12213sc/index.htm.

N3t W0rK3r
Level 3
Level 3

Hi Derrick,

I found the following document (PEAP Application Note) quite useful in similiar efforts I have made recently. I don't have everything working 100% yet, but I am very close. Hope its helpful to you.

http://www.cisco.com/en/US/customer/products/hw/wireless/ps430/products_technical_reference_chapter09186a008025d6ee.html#wp1058010

Regards,

John

Review Cisco Networking for a $25 gift card