08-16-2016 05:13 AM - edited 07-05-2021 05:38 AM
Does anyone know how to join -b regulatory domain access points to a controller properly? I have a 2504 running 8.2.121.0, a known firmware release that supports -b access points. I cannot get the AP's to download the firmware and register properly. They stay up for a few minutes and then reboot repeatedly. I do not currently have console access to them. Do these need primed like the universal AP's do?
08-16-2016 06:12 AM
Hello,
Yes they need to be primed in a special way so that the ap learns the country code.
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/ux-ap/guide/uxap-mobapp-g.html
That said only B domain access points can share country codes with other B domain access points. Once you have one enabled keep it close to configure others.
******************************************************************************
HTH
Please rate helpful post!
www.my80211.com - Blog by a WiFi engineer for WiFi engineers
www.wifitraining.com/about-wifi/ - WiFi Training by hands on WiFi Engineers, Experts and Cisco Wireless VIPs
08-16-2016 07:08 AM
Thanks for the reply!
So just to clarify, you prime a B domain access point, the same way you do a universal?
08-16-2016 07:14 AM
You know what I was responding to two post and I mis typed here. My apologies. No if its a B domain you do not have to have it learn the country code.
What access point model is not joining ?
08-16-2016 07:26 AM
AIR-CAP2702e-B-K9
08-16-2016 07:41 AM
Can you do the following debug ob the WLC while the AP joins and drops off ?
debug lwapp events enable
08-16-2016 07:57 AM
I have attached the debug. We are specifically looking at the 2 access points that are 10.0.20.101 and 10.0.20.102. I have a primary and secondary controller, running the same config and code.
08-16-2016 07:58 AM
I dont see the attachment ..
08-16-2016 08:09 AM
08-16-2016 08:39 AM
You see this
*spamApTask4: Aug 16 11:26:40.050: apType: Ox26 bundleApImageVer:
It should show an ap image but it doesn't. Im not sure why. But can you reboot the WLC and if that doesn't work any way you can update to the latest code.
08-16-2016 08:45 AM
I did, but honestly, I wasn't sure what it meant.
It is currently running the latest code 8.2.121.0, and has been rebooted multiple times.
08-16-2016 08:45 AM
I have had it on the latest 8.0 code and now the latest 8.2 code, and have not had luck with either image.
08-16-2016 09:10 AM
Let me poke around.
08-16-2016 12:25 PM
From the monitor screen take a screen shot of your version of code.
08-16-2016 01:55 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide