Hello, I use two network controllers WLC 2504 each have 10 licenses installed on the AP. Currently connected AP is 6/6 on both controllers. Is there a possibility of full coverage of 12 temporary AP in one controller in case of failure?
Dear All,I configured the Access Point with the SSID and other necessary configuration, i am able to view and connect to my SSID through laptop.But i am unable to view it on my Apple or Android phone.Can anyone please let me know what must be the iss...
Greetings, we have two 5508 WLC's in our HQ, all AP's connected in local mode and heavily use MS Lync over wireless.We have 5 SSID's configured for various functions, one of which is the corporate SSID which users associate to by default, at present ...
Is there a list of devices that is current list of devices that Cisco Prime is able to manage (ie: configuration files, images, health and status, etc)?I more specifically need to know if Prime manages IPS-4200 series, As one of my requirments is to ...
Hello,I am planning a dense deployment of access points in an area and discovered this option when looking through the WLC. This is more of a question of what this is and why it isn’t enabled by default. When I read this option I take it as, if you h...
Good Morning.We were looking to deploy wireless VoIP phones into our environment. These phones have a PTT feature which utilizes Multicast.I was looking into configuring Multicast mode on the wireless controller and access points in our network. Do y...
We have a 5508 that has just been upgraded from 7.0.240 to 7.6.100 with many 1142's, 3502's, etc. Our wired network is HP 5406zl's POE on every port and plenty of power available for POE. As soon as we upgraded our 1142's to 7.6.100 we started gett...
I have connected a 2602 AP to one of the PoE-ports on a 2504 WLC running ver 7.5.102.0. But there's no PoE going to the AP, and it doesn't turn on. There's probably something I have misunderstood here so sorry for asking this stupid question, but why...
I have one SRW2008MP-K9-NA , PoE+ switch, can i powering up the ap AIR-CAP1532I-N-K9 ? if not so please tell me how can i powering up this device.thanksDebu
Hello.After upgrade to new controller version 7.5 on my 5508, I have two access points that won't connect to controller anymore.Before the upgrade, I pre-downloaded the new images to all access points and that worked well.I now connected to one of th...
HiI have two WLC 2504 with 7.6.100.0, one of them defined as HA. I have an RF-Group, AP Fallback is enabled and Failover works perfect. Fallback of the AP's works, when I define Primary and Secondary Controller on the AP's High Availability Tab, but ...
Flex 7500Software Version: 7.2.103.0I have a Flex 7500 with 200 1142AP's working fine in remote office and local setup. We have since purchased 3 OEAP 602's and looking to distribute to teleworkers. I have configured the OEAP to point to the NAT'd IP...
Hello,Does anyone have any experience with the following setup:We want users to authenticate thru Dot1x with their Windows credentials. The RADIUS server for dot1x will be ACS that uses Windows DC for authentication. Then we would like for the ACS ...
