I have installed a 2106 WLC with software version 6.0.188.0. I can happily see 1142n access points but I wanted to know if it supports 1010 access points? I have tried looking for the documentation but I have been unsuccessful, hope you can help! Ki...
I currently have an issue with a 7921G phone which authenticates with the access point ok but is showing DHCP timout on the phone itselfOur setup is as follows a Cisco 4400 Wireless Lan controller, a 4510 chassis based switch which supplys dhcp range...
Can someone explain to me why two grounding studs on this device as per Figure 2.2 ofhttp://www.cisco.com/en/US/docs/wireless/access_point/1300/installation/guide/1300hig_book.pdfThanks,Mark
Hi,This is our current wireless configuration. Our stand-alone AP's (1140 and older 1100's) are using Windows RADIUS authentication with WPA2/AES. We would like to broadcast the SSID for our wireless since currently we are not.I have enabled the "S...
I wonder whether there is an Access Controller that is able to output Ethernet frames as if they were generated by the mobile stations, therefore providing a bridge between the WLAN and the fixed LAN to which it is connected.
I have several AP's throughout my facility. I am having a problem where a computer does not connect to the closest AP and therefore has slow performance. As far as I know the computers are set to to connect to whichever AP has the best signal strengt...
When the Access Point (AP) and Access Controller (AC) communicate over an IP network (using UDP):1- Is the MAC address of the AP's wireless clients known at some stage by the Access Controller?2- I do not have a clear picture about DHCP (for wireless...
Hi All,I am planning on buying a third party cert to install on a WLC. My question is, does the "Common Name" that I include on the request for the certificate need to be an actual public domain? This is just for a guest scenario and I dont want to u...
i can't connect 1252 over 54 mbps i can connect @ 130 - 150 mbpsi use intel 5300 AGN chipset also i set security in 1252 in WEP or WPA i can connect it @ 54 mbps why ?please tell me setting with 1252 or configuration thanknow i setting only bvi 1 and...
I just added 5 AP's to our existing wireless network and it put us over our license limit. I am working on getting a new license from Cisco but I was wondering what the repercussions are when you go over the limit. Do you lose some functionality? So ...
Hi All, just a question of thumb. I practice to configure all Autonomous Scenarios, Bridges including. If i try to configure Authentication of a WGB or NR Bridge with the Root Bridge or AP based on EAP-Fast and local Radius, i have to configure Netwo...
This is more of a curiousity question than anything. Is there a way to bypass ACS and authenticate wireless clients using AD? We run a WLC 4400 with version 4.2.207.0 and I was just wondering.
Could someone tell me how how to get my clients association on the embeded WAP on the 891 wireless router to ensure it is connected on 802.11n? When i do the show dot11 associations all-clients command, what exactly I am looking to see if the clients...
