Wireless

When configuring WEP with CKIP/CMIC, broadcast key rotation had to be selected separately within the AP configuration. Does WPA by default include broadcast key rotation or do I have to configure it?Also, is it beneficial to select any of the values ...

I have a client who is seeing fairly consistent problems with their 7920 phones aquiring a DHCP address. The phone boots and associates to the AP quickly, but then stalls on configuring DHCP. After a couple of minutes the phone gets a DHCP address an...

I am unable to get some of my clients to pull DHCP addresses when associated to my APs when I have VLANs configured on the APs. Once I delete the VLANs my clients can pull IPs, but when I put the VLANs back on they can not pull DHCP addresses. I an g...

Hello all,I have a PCI a/b/g card that was working but, I had to re-install windows on this PC and now the card shows packets transmitted but, none received. I am using the 2.5 drivers. My 1100 ap shows the card is associated. It passes the network t...

HelloDuirng roaming (we use for auth. leap) between the 5Ghz to the 2.4Ghz and vice versa we lost up to 5 pings. Roaming in the same band we just lost maximum 2 ping. We have 1200 and Cisco a/b/g Cards. Is it recommend to have profiles on the wireles...

(This was also posted under "Getting Started with Wireless")I could use some recommendations from the forums here. I have an 8-story apartment building in which the building management wants to install wireless to cover everyone and every floor. They...

Does the ACS 4.0 support LEAP?

I am installing a point to point bridge link using 1400 briges w/power injectors. The bridges are installed but the link goes up and down about every few minutes. When it does connect, it starts out at a low dbm but eventually ends up in the 80's and...

Hi.I've 2 PC's comunicating on IPv6 through an AP Cisco 1200. Everything's fine except that messages, called Router Advertisements (RAs), are not being forwarded by the AP.I tought that might be because this RAs are being sent to the multicast L2 add...

I was wondering why the 1300 30mW power limitation when running at the 802.11G speeds? Is there some type of regulation around this?Thanks.

Dear all,Is it possible to load a config-file from a bootp-server to an access-point?Which commands will I need on the cli?THX for the answers Kind regards,Ingo

Has anyone configured a PIX to allow Checkpoint Secure remote client through a PIX to a remote Checkpoint F/w. We have created a static mapping for the client, although NAT'd and he can connect and authenticate to the Checkpoint F/W but DNS/WINS does...