Wireless

We have a single access points that connect to a Cisco 3500XL switch. We have configured that port to carry 2 vlans.interface FastEthernet0/44 switchport multi vlan 1,20,140 spanning-tree portfast When we do this we can not ping the WAP. When we conf...

Hi,I am trying to implement EAPOW for my wireless LAN and using RADIUS for authenication. In my design, I have a RADIUS server in my server farm and another RADIUS server at my DMZ of the firewall. The one at the DMZ is for remote users to connect in...

Is there a setup that i can use for billing on a wireless LAN?This billing system has to be able to tell how long a certain user (wireless card) has been on line. I'm looking for something like the BBSM. That product might be it, but i think it does ...

I was wondering if there is a way to import mac addresses into the acs, it's not very fun to add all the mac addresses by hand one at a time? is CSUtil.exe a way of doing this?

Currently I'm working on a trial for a client. They're currently running Cisco aironet with LEAP. They've contacted me to do a trail to enable EAP-MD5 over their existing Cisco Aironet infrastructure. <client>---<AP>---*Network*---<ACS3>Have anyone s...

Has anyone bought a laptap or other handheld device that had the MPI350 card built in. One of my resellers stated that this card is only available to OEMS, and not to the general public. I would like to use this card in My dell laptops to take advant...

I have set up a wireless network with one access point. Everything is working fine for one minute and then they access point seems to have lost connection with the wired network. It starts up all over again. The leds are reacting the same as when I s...

One customer want to use there HP printer in a wireless enviorment......I thought the ports were different....any one did this?Thanks!

I have a building to building setup and one of my 340's died. Can I replace it with a 350 and will my connectivity be stable? I frequecy spectrum is about the same but the 350's goes up higher. Will most of the channels work?Thanks,Bill

I have a 340 bridge that when you turn it on it displays "no vaid configuration file" and then proceeds to do a stack dump. Does any one know how to reset this bridge. I can't get the configuration screen to stay up long enough to select the reset op...

Can this be done... [Client]<---wlan-->[AP]<--eth-->[cisco1700]<---serial(leasedline)-->[3600(nas)] What i'm doin is to enable pppoe over wlan. Can cisco AP bridge the client to the nas. What are the requirements and settings for the AP/1700/3600 ?? ...

Cannot find the def in the Mobile Wireless Glossary at www.cisco.com

It appears the Nortel phone system operates at 1.92gHz range. It seems like there should be enough separation between the freqs, but has anybody installed the two systems side by side? any problems or issues?Thanks

I am looking for any info on available or coming products that offer wireless phone/radio voice capability over 802.11b or other wireless networks. Basically a modern and cost effective alternative for an in-house radio network based on the LAN infra...

I have two 350 Bridges - one root, one non-root w/o clients. We're using Air-Ant-1729 antennas. The bridges are in opposite buildings that are directly across the street from each other. Our signal strength doesn't go higher than 62%. What factors mi...