07-26-2005 03:30 PM - edited 07-04-2021 11:00 AM
can someone tell me the best way to get the wifi interface up and running on the cisco 1800. I created a ssid for dot11radio O interface. I was able to bind it to one of my vlans. I assigned it an ip address and used no shut. For authentication, i made it open. I am able to ping the wifi interface from the router's CLI. I run show int dot11radio0 and it shows the interface is up. I run show dot11 association and it shows my wifi interface and vlan. For some reason I can not see the ssid being broadcast over the wifi network. If anyone can provide some direction or a sample of a working wifi config that would be great. Im not really concerned about security or wep at the moment. I just want to the simpliest solution for enable wifi on one interface and have the ssid broadcast on the wireless network.
Thank you
08-01-2005 07:53 AM
To configure the Cisco 1800 for wireless connectivity the following needs to be configured.
Perform the following tasks to configure this network scenario:
1.Configure the Root Radio Station
2.Configure Bridging on VLANs
3.Configure Radio Station Subinterfaces
For information on configuring the above mentioned parameters refer to the following URL.
02-06-2007 01:17 PM
Have you got this working? I have same issue?
02-14-2007 03:35 PM
IOS won't broadcast the SSID unless "Guest-Mode" is set. I think for the 1800's dot11 interface there is only one BSSID allowed, so make sure you have guest-mode enabled on only one SSID. Don't hold me to that.
The other big thing to do is simply enable terminal monitor from exec. If you missed a configuration step, you'll get a syslog message indicating why the radio wasn't enabled.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide