Wireless

Hi all, I have wireless network with Wireless Lan Controller 2100 and Light Weight Access Point 1300.All thing run well.But when we need some change on network, i changed IP of LAP 1300 to incorrect IP address. So it can not communicate with Wireless...

I have an AccessPoint (Cisco 1242) that has no Ethernet connection available.Is it possible to use one 802.11a interface of the neighbor Access Point as bridge so that the Access point without Ethernet connection can get a connection?

I have an AccessPoint (Cisco 1242) that has no Ethernet connection available.Is it possible to use one 802.11a interface of the neighbor Access Point as bridge so that the Access point without Ethernet connection can get a connection?

I have an AccessPoint (Cisco 1242) that has no Ethernet connection available.Is it possible to use one 802.11a interface of the neighbor Access Point as bridge so that the Access point without Ethernet connection can get a connection?

Hello All, Has any one good good reference meterial on how to deploy In-Band - Virtual NAC Gateway for Non Meshed Wireless ??

Hello, I have problems configuring a bridge interconnection between two site of a network. I am using two 1310 APs and two 2960 cisco switches with the following configuration:--------------------------------------------------------------------------...

We have an monitoring system to monitor all the access points transmit and receive errors.There are four column name "Receive Error", "Receive Discard", "Transmit Error" and "Transmit Discards".I have notice that there are a lot of transmit discards ...

Is there a way to create a bridge between a Linksys WAP54GPE and a Cisco 1310?Linksys states Bridge and Repeater are only available with other Lonksys products. But the Aironet 1310 offers the universal workgroup bridge mode. Does this work?As well i...

I need to filter by IP addresses the devices passing *through* (not associating with) a 1300 configured just as a point2point bridge. can an extended ACL do this on this device, and if so, do you configure ingress filtering on the bvi or fasteth inte...

Hi, can anyone tell me exactly what ports I need to open on my FW in a datacentre to remote branch scenario?WLC located on it's own DMZ and the FW is between WCS,WLCS and LAPthanksTyrone

I have a Weird Problem. I have a remote access point which I am able to ping. Users have no complaint accessing it. The problem is that I am unable to login by telnet or HTTP into it. Configuration has telnet and HTTP access in it. What may be the pr...

Hi,There are lots of reports available in WCS. Can anyone give figures what are the common reports that WCS admin will need to enable and schedule regular reports?Leon