C2960-X POE Switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-10-2019 11:55 PM - edited 07-05-2021 09:49 AM
Hi All,
Here i have an 48 Port C2960-X PoE.I connect the PBX's, and 3 Aruba AP's.
But the the problem is Aruba AP couldn't get the exact power,It works under power save mode.
I have a question , Why this PoE can't supply the exact power for the Access points ?
Appreciate the fast replays.
- Labels:
-
Other Wireless Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 01:15 AM
- Connect the AP , and after a while (5 mins) , issue show logging on the switch , you will then probably get additional info, as to why (exact) power cannot be provided.
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 01:27 AM
What are the requirements of the Aruba APs. What Model are they?
Try enabling LLDP if not already enabled: lldp run
Can you share a show power inline from the switch and show run interface <interface AP connected>
Do you see any error on the APs?
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 02:38 AM
It's an Aruba 315 AP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 05:09 AM
Can you please share the Command lines for enable LLDP
Thanks and Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 01:29 AM
<<< Please help the community by marking useful posts helpful, or accept as a solution if it resolved your issue >>>
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 02:40 AM
Thanks for the information.I'll let you know what the after.
i appreciated
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 05:06 AM
Can you share the commands for enabling LLDP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2019 05:09 AM
SUMMARY STEPS
1. enable
2. configure terminal
3. lldp run
4. interface interface-id
5. lldp transmit
6. lldp receive
7. end
8. show lldp
