Hi, I have a Cisco 1832I AP running in Mobility Express mode. The problem is I can get the builtin WLC's webpage. But it is not showing the AP. There are no any other Cisco devices on the network. Also I can't afford a WLC for this one Access Point. ...
Forum Posts
Resolved! Mobility Express 8.5.161.0 AP support
Hi Guys, I'm running Mobility Express 8.5.161.0 with AP 1832i.I'm wondering if I can enroll AP 1142N into the Controller ? Thanks for your support. Regards,Jean-Christophe Valiere
Question (we are currently in design phase of this project)Client migrating from WLC 5508 (EoS) to new C9800-L-C-K9. Client has geographic locations in US, Europe (Germany and UK) as well as Canada. Most AP in US. Today all operating/registered to ...
Hello,I have used the MR42 to get the real time location but the location coordinates of BLE tags are not accurate OR approx. OR device is sending there location when ever the device seen the BLE tags, Is there anyone who can share their experience p...
Resolved! Guest Wireless and DNS
During our implementation of Guest Wireless (currently ongoing), we are trying to decide where to point to for DNS.We have a 5508 WLC in our Internet DMZ and it acts as the Anchor WLC. This WLC is also used as the DHCP server for the Guest Wireless c...
i am facing an issue with my ap and controller Here is my equipmentCisco Catalyst 3750 series POE switchCisco WLC 2100 Series Actual 2112 version 7.0.252.0Cisco Air-AP1042N-E-K9Here is the Configuration i have Done
Resolved! Best approach to replace AP and WLC
Gents, I have AP 1042 | 1832 and WLC 2504 which will be replaced by AP 9120AX and WLC 9800-L. Can any one of you recommend the best approach to replace the infrastructure with minimum impact. Thanks,Edouard.
I currently have 7 2602i access points connected to 5 different 6530 switches. If I take a new laptop that has never connected to the access points, they will not connect to the 'network', but if I take it to another are to a different access point (...
Resolved! Access Point Interference with Speaker
Hello, We will be installing Cisco Access Points C9130AXE-B in the excercise room and basketball court. AP will be installed at the eleavation of 15'. Will it interfere with Speakers at the same height?
Resolved! AP no joint vWLC
Team,I have an AP 2702i that was factory reset and when I connect it to vWLC 8.5.161.0 it cannot register. Attached logg of the AP, has anyone seen this error ?. AP500f.8094.85a0#*Aug 19 19:19:37.999: %DTLS-5-SEND_ALERT: Send FATAL : Close notify Ale...
Hello,I recently upgraded my 1830 AP to version 8.10.130.0. After completing, I am experiencing the following:1. LED indicator changes Green->Red->Amber repeatedly2. No access points are listed in the Access Points table in Wireless Settings. And...
Hey all We recently purchased a Aironet AP1852I-E-K9 unit to use as a stand-alone WAP extension for an existing wired network. All it had to do was add wireless tablets to our existing wired network. There are no other wireless devices, no wireless c...
Hi Team, I wanted to know, do I need to procure 2xAP adder license if I am running virtual WLC as Primary and Secondary in same mobility group. i.e 1 adder license for each vWLC.
Hi, i have the following issues on a cisco air ap 2802I-E-K9e choose one of the following boardsand starts over and over again Please choose one of the following boards:1. 3K2. 2K (new)3. 2K (proto)4. Milos5. 2KH6. 3KVE (v-sku)7. 3KH/3KA/4K8. Duploi...
I have some older computers/consoles. That do not have good wifi, or the wifi is not workingI have my home network which is wifi because I am unable to wire the house for ethernet for a few reasons. The Ethernet does not reach the location for the ol...
