cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
401
Views
10
Helpful
5
Replies
Karsten_Andersen
Beginner

C9800-CL Not enough free memory to run this command, aborting

Hi you all

 

When doing a radioactive trace on a C9800-CL, it starts the the trace but, when we chose to generate the log it says ->Not enough free memory to run this command, aborting. Unfortunately I do not know the hardware layout on the hyper visor yet. But lookning at the memory on the C9800 it's only using 25%. How to start Troubleshoot this issue

 

Software 17.6.1

AP 9120AXI

1 ACCEPTED SOLUTION

Accepted Solutions
Arshadsaf
Rising star

Files are written in memory first then on disk bootflash:/tracelogs, when it reaches the maximum size it follows FIFO. So as per the theory if your bootflash is having free space this should work. I would also keep an eye on  memory utilization and if all seems ok, I would reach out to TAC.

______________
Arshad Safrulla

View solution in original post

5 REPLIES 5
Arshadsaf
Rising star

Is the VM running with correct and dedicated resources? Can you check the bootflash free space and clear all unwarted files. (dir)

______________
Arshad Safrulla

Thanks I would trye the suggested.

Unfortunately, the above did not work. VM is create via OVA, resources are allocated via OVA config.4 cores, 8 GB ram, 16GB storage. there is 3GB available out of 6.2GB one the boot flash

Arshadsaf
Rising star

Files are written in memory first then on disk bootflash:/tracelogs, when it reaches the maximum size it follows FIFO. So as per the theory if your bootflash is having free space this should work. I would also keep an eye on  memory utilization and if all seems ok, I would reach out to TAC.

______________
Arshad Safrulla

View solution in original post

Karsten_Andersen
Beginner

Hi Arshadsaf

 

Thank you for your time, I think ill reach out for TAC.

 

Have grate weekend.

Create
Recognize Your Peers
Content for Community-Ad