05-15-2012 02:09 AM - edited 07-03-2021 10:10 PM
I have searched and asked round for this the last weeks. Can't find the answer.
When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?
Is it possible to make a setup with i.e. WPA/PSK where the AP keeps working after a reload in standalone mode ?
Chears
Rasmus
05-15-2012 03:25 AM
When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?
When your WAN link(s) goes down and your FlexConnect (H-REAP) WAP reboots, it will not service anything/anyone.
05-15-2012 03:30 AM
Thanks. That was what I inspected but could not find any documentation for it.
06-22-2012 02:40 PM
After reboot it is expected that hreap/flexconnect AP to retain the config and serve local clients, if it is not doing so then it is broken. However, this behavior is not documented in cco.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide