08-05-2016 10:34 AM - edited 07-05-2021 05:34 AM
i plugged the AP 1142N the light keeps blinking i've wait for a while i have seen the AP registered in the WLC which is usually gets registered by it self. i console to the AP the interface keeps flapping please help
5 17:33:25.045: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Aug 5 17:33:25.050: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Aug 5 17:33:26.040: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to up
*Aug 5 17:33:26.045: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down
*Aug 5 17:33:26.071: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Aug 5 17:33:27.071: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
08-05-2016 11:45 AM
Hi Khalid,
Paste the output of these commands:
sh sysinfo from WLC
sh version from AP
Also paste the complete bootup process from AP console.
Regards
08-05-2016 12:01 PM
08-05-2016 12:02 PM
08-05-2016 12:17 PM
which method are you using to discover WLC ?
Your AP and WLC are in diff subnet/vlan ?
Also paste the output of this command:show auth-list
08-05-2016 06:17 PM
Product Version.................................. 8.0.121.0
There is a very good reason why Cisco no longer allows people to download this specific firmware. I strongly recommend to upgrade the firmware first before doing any troubleshooting.
08-07-2016 04:50 AM
This version can still be downloaded, 8.0.120.0 has been removed.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: