11-17-2015 08:57 AM - edited 07-05-2021 04:15 AM
Hi, I just bought the Cisco 3702e AP and I am unable to connect to it using IE and it's IP address. I can Ping the IP and I can Telnet into it but I am not any good at using the Command Line Interface. I am trying to replace my current Cisco AP1024N AP with the faster 3702E AP, I can connect to the AP1024N using IE and the IP address without any problem. Can anyone assist me with this?
11-18-2015 01:54 AM
11-18-2015 09:17 AM
Thanks, the link does not address the 3702E AP, I need to be able to operate this AP in Autonomous mode, it is currently looking to find a "CAPWAP" server so I think it is running as LWAPP?
11-18-2015 10:23 AM
You are correct, you have a lightweight AP.
11-18-2015 02:44 PM
Can use this process to switch to autonomous mode? https://www.youtube.com/watch?v=T8T__dkg7P4 , if so, I need to find out if there is firmware available for the CAP3702E to run in the autonomous mode.
I just found this as well, apparently the firmware is available for download, (with a current support agreement in place).
https://supportforums.cisco.com/discussion/12153196/access-point-doing-80211ac-autonomous-mode
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide