I have a very basic config, 40-bit wep, no vlans, etc. When my AP (1231G) is configured to xmit on ch 1 no one can connect. I have Cisco clients and others. Any other channel works fine. Any ideas? I am on IOS 12.3(2)JA Here is my config:
version 12.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname BTLR-AP1200#1
!
enable secret
!
username admin privilege 15 password 7
ip subnet-zero
!
no aaa new-model
!
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption key 1 size 40bit xxxxxtransmit-key
encryption mode ciphers wep40
!
ssid wireless
authentication open
!
short-slot-time
speed basic-5.5 basic-6.0 basic-9.0 basic-11.0 basic-12.0 basic-18.0 basic-24.0 basic-36.0 basic-48.0 basic-54.0
rts threshold 2312
channel 2462
station-role root
no cdp enable
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface FastEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 172.18.23.10 255.255.255.0
no ip route-cache
!
ip default-gateway 172.18.23.1
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
ip radius source-interface BVI1
logging snmp-trap emergencies
logging snmp-trap alerts
logging snmp-trap critical
logging snmp-trap errors
logging snmp-trap warnings
bridge 1 route ip
