04-22-2021 12:48 PM - edited 07-05-2021 01:12 PM
Hello everyone,
I have the following problem, I need a catalyst 9120axi AP with EWC in a small office. I only have access ports there because I only have a small broadband router there. Is it possible to get the WLANs on the native VLAN, like the management? Unfortunately I don't know how. Best wishes
Frank
04-22-2021 01:14 PM
Yes, you should be able to do it.
You can configure EWC management on vlan 1 and that should be it.
HTH
Rasika
*** Pls rate all useful responses ***
04-22-2021 01:22 PM
Ok, I also get in touch with the management. So I'm on the management website. But when I set up a WLAN, it does not come out via VLAN 1 like the managed interface. I have only one access port in the broadband router (FritzBox), which accepts the native Vlan. That's why I come to management. Only WLAN does not work, or the client does not receive an IP address from the DHCP.
04-23-2021 06:19 AM
It definitely works - I have one working like that.
Do not configure/use vlans at all. Configure the EWC IP directly on Gig0 interface.
My EWC interface config:
interface GigabitEthernet0
mac-address xxxx.xxxx.xxxx
ip dhcp client client-id GigabitEthernet0
ip dhcp client broadcast-flag clear
ip address 192.168.x.x 255.255.255.0
negotiation auto
end
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide