CBW 150AX and CBW145AC

[pafanelli]

Hello community,

I've a wireless network done by 150AX and 151AXM. It works fine. Now I've to add on the same network a CBW 145AC because need few eth ports in an specific area.

Is there a way to do that ?

Thank you in advance for your time and support.

[balaji.bandi]

check adding new AP to exiting network :

https://www.youtube.com/watch?v=klydLJm_v0A

Also admin guide for reference @:

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/csbap/CBW_WiFi_6/Admin_Guide/b_cisco_business_wifi_6_admin_guide/m_8_appendix_a_supporting_topics.html#id_124720

[pafanelli]

Hello Bandi,

I didi it but doesn't work. What's why 150AX doesn't support 145AC as subordinate AP.

Thus I ask this technical community if there is a workaround or trick. Two Primary APs can't exist on the same network, but where is a way to avoid one AP listen the other ? I tried to set up in Wireless Settings->Wllan Users->Local MAC address the other MAC Address as Blocklist type but doesn't work; you can clearly see in the Logging a WCAP packet arrived and ignored because the other AP model in not supported.

Any other suggestion ? I'm willing to configure one AP off-line and not manage it by GUI (blindly), the important is it publish out own SSID and works as standalone AP

I don't have a L3 router so both APs have to stay on the same network.

Thank you in advance,