cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1822
Views
0
Helpful
4
Replies

Cisco 2702 convertion from ligthweight to autonomous

marlon.baylon13
Level 1
Level 1

Hi Cisco Team,

Can you help me on to convert the Cisco 2702 to Autonomous mode.

So far i already did some config on the AP.

Pls see below :

Light Weight to Autnomous CLI Commmands :
-set ENABLE_BREAK yes
-set IP_ADDR 192.168.0.1
-set NETMASK 255.255.255.0
-tftp_init
-ether_init
-flash_init
-tar -xtract tftp://192.168.0.2/ap3g2-k9w7-tar.153-3.JD3.tar flash:

After Uploading the image files this is the next command:
-set BOOT flash://ap3g2-k9w7-mx.153-3.JD3/ap3g2-k9w7-mx.153-3.JD3
-boot

Unfrotunately  after boot it says error boot no image found.

Thanks

Marlon

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame

After Uploading the image files this is the next command:
-set BOOT flash://ap3g2-k9w7-mx.153-3.JD3/ap3g2-k9w7-mx.153-3.JD3

Using a TFTP Server to Return to a Previous Release

I get same error after following the guide config.

Any Option or suggestion?

Thanks,

Marlon

I get same error after following the guide config.

I can't read people's mind.  What is the exact error message?

Did you solve it? Could you tell me how?

Review Cisco Networking for a $25 gift card