cisco-3802 Ap

[Anjana A]

Hello Team,

We are using wlc of model:5520/airos-8.10.151.0 AP-Model: 

these two access points are  working with the same ip address.

These are local access points in the same location, can you pls confirm how it is working.

AP Name Slots AP Model Ethernet MAC Location Country IP Address Clients DSE Location
------------------------------ ----- -------------------- ----------------- -------------------- ---------- --------------- ------- --------------
ap-01 3 AIR-AP3802I-D-K9 vv:ff:ff:ee:ww:ee: default location IN 10.10.10.10 0 [0 ,0 ,0 ]

AP Name Slots AP Model Ethernet MAC Location Country IP Address Clients DSE Location
------------------------------ ----- -------------------- ----------------- -------------------- ---------- --------------- ------- --------------
AP-02 3 AIR-AP3802I-D-K9 a0:89:09:97:89:00 default location IN 10.10.10.10 0 [0 ,0 ,0 ]

Regards,

Anjana

[Arshad Safrulla]

Can you post a show AP summary output from WLC? DId you try rebooting the AP's and also from the local DHCP server which is issuing IP's to AP?

[Sandeep Choudhary]

If both Aps are using the same IP then there must be an IP address conflict. Wireless Network operations  may be disrupted as a result.

As @Arshad Safrulla  asked, paste the output of this command:  show ap summary

Regards

Dont forget to rate helpful posts

[Rich R]

The IP shown in "show ap summary" can be confusing/misleading.  If (like us) most of your APs are behind NAT then every AP at a site shows the same IP (the NAT IP).

"show ap config general <ap-name>" will show how the AP is actually configured including:

IP Address Configuration......................... DHCP (or static)
IP Address....................................... A.B.C.D
IP NetMask....................................... W.X.Y.Z
Gateway IP Addr.................................. A.B.C.E
NAT External IP Address.......................... F.G.H.I:n  (NAT IP and port number)