09-18-2022 09:35 PM
Hi All,
WLC 9800 17.6.4
How we do configure Mobility Group on a WLC HA setup?
We have two units of WLC configured as HA with RMI+RP, thus we manage WLC on a single WLC active ip address & config is auto replicated to standby WLC.
Is peer mobility config not needed since it is already a HA setup?
We tried test configuring it anyway to point peer mac address to standby WLC unit with its standby RMI ip address, however we are getting Status "Control and Data Path Down"
Appreciate any advise
Solved! Go to Solution.
09-18-2022 11:25 PM - edited 09-19-2022 04:19 AM
>....We tried test configuring it anyway
- You don't need peer mobility config in this HA setup , check intended (/final) configuration of the (active) 9800 with the CLI command : show tech wireless , have the output analyzed by https://cway.cisco.com/
M.
09-19-2022 02:26 AM
Since both WLCs shared single management IP address those 2 units won't act as two individual WLCs. Therefore you cannot configure these two units individually (same config shared by both units).
In short, no mobility configuration needed between Active/standby units.
HTH
Rasika
*** Pls rate all useful responses ***
09-18-2022 11:25 PM - edited 09-19-2022 04:19 AM
>....We tried test configuring it anyway
- You don't need peer mobility config in this HA setup , check intended (/final) configuration of the (active) 9800 with the CLI command : show tech wireless , have the output analyzed by https://cway.cisco.com/
M.
09-19-2022 11:01 PM
Thank you for the confirmation. No peer mobility needed in HA setup that is!
09-19-2022 02:26 AM
Since both WLCs shared single management IP address those 2 units won't act as two individual WLCs. Therefore you cannot configure these two units individually (same config shared by both units).
In short, no mobility configuration needed between Active/standby units.
HTH
Rasika
*** Pls rate all useful responses ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide