cisco aironet 1130g and windows 2003 with cisco ACS

[Dilruwan Rathnayake]

  hi

i  have configured windows 2003 server with  DNS ,Active directory users and dhcp server.  and configured my cisco 1130g AP .

i have installed cisco access control server 4.0 because i use LEAP authentication protocol and for the ACS for network configuration i give aaa client ip addresss as AP interface ip and  same shared secret for the AP and ACS,.

so  when i log to wifi it ask username and password

problem is lap top cannot have a ip address my dhcp server not issue any ip address .

my hiper terminal massage is like this when i connect to wifi 

help ...thank you...

[Nicolas Darchis]

You need to configure your client for the right EAP type. your client doesn't do leap on its own for example ...

Nicolas

[Dilruwan Rathnayake]

i configured both my access point and ACS server in LEAP type..

is it enough..

[Nicolas Darchis]

As I mentioned now several times already, it is the client and ACS which do the PEAP. The Access point doesn't have to be configured for an eap type. What you did on the AP was setting the AP as a radius server which is duplicate work with what you did on ACS.

So you need on your client to configure either PEAP or LEAP.

Nicolas