Re: Cisco C9800-L WLC is not being synchronised with NTP

King_1988 · ‎08-19-2020

Hello,

Cisco C9800-L WLC is not being synchronized with NTP server. What could be the issue?

JPavonM · ‎08-19-2020

Which interface are you using for NTP communications? Have you checked there is no firewall or that traffic is allowed in the firewall policies?

Could you share your NTP config please?

HTH
-Jesus
*** Please Rate Helpful Responses ***

King_1988 · ‎08-19-2020

Hi Pavon,

There is no Firewall. Other devices are being synchronized successfully. I have attached screenshot of my GUI of 9800-L.

I have only added NTP server in 'Time' tab. Is there any other configuration needed?

Scott Fella · ‎08-19-2020

Remove it and add it again... look at the vrf as it depends on how you have your management configured. Either way, add it again and or try an external NTP for testing.

-Scott
*** Please rate helpful posts ***

Rich R · ‎08-20-2020

This works fine for me:
ntp source GigabitEthernet0
ntp server vrf Mgmt-intf <server-ip>

------------------------------
Please click Helpful if this post helped you and Select as Solution (drop down menu at top right of this reply) if this answered your query.
------------------------------
TAC recommended codes for AireOS WLC's and TAC recommended codes for 9800 WLC's
Best Practices for AireOS WLC's, Best Practices for 9800 WLC's and Cisco Wireless compatibility matrix
Check your 9800 WLC config with Wireless Config Analyzer using "show tech wireless" output or "config paging disable" then "show run-config" output on AireOS and use Wireless Debug Analyzer to analyze your WLC client debugs
Field Notice: FN63942 APs and WLCs Fail to Create CAPWAP Connections Due to Certificate Expiration
Field Notice: FN72424 Later Versions of WiFi 6 APs Fail to Join WLC - Software Upgrade Required
Field Notice: FN72524 IOS APs stuck in downloading state after 4 Dec 2022 due to Certificate Expired
- Fixed in 8.10.196.0, latest 9800 releases, 8.5.182.12 (8.5.182.13 for 3504) and 8.5.182.109 (IRCM, 8.5.182.111 for 3504)
Field Notice: FN70479 AP Fails to Join or Joins with 1 Radio due to Country Mismatch, RMA needed
How to avoid boot loop due to corrupted image on Wave 2 and Catalyst 11ax Access Points (CSCvx32806)
Field Notice: FN74035 - Wave2 APs DFS May Not Detect Radar After Channel Availability Check Time
Leo's list of bugs affecting 2800/3800/4800/1560 APs
Default AP console baud rate from 17.12.x is 115200 - introduced by CSCwe88390

Rasika Nayanajith · ‎08-24-2020

Verify it in CLI

9800#show run | in ntp

9800#show ntp association

9800#show ntp status

HTH

Rasika