cisco LAP 2602 can not join Virtual WLC

[Ali mosbah Abdo]

dear all, 

i just install Virtual WLC and i remove WLC 2504 , i install & configured it , but LAP can not join. it was work fine with WLC 2504.

i used the same network topology with the old WLC.

i receive this error logs.

*spamApTask4: Feb 04 06:01:30.082: <<<<  Start of CAPWAP Packet  >>>>
*spamApTask4: Feb 04 06:01:30.082: CAPWAP Control mesg Recd from 10.192.200.93, Port 26711
*spamApTask4: Feb 04 06:01:30.082:              HLEN 4,   Radio ID 0,    WBID 1
*spamApTask4: Feb 04 06:01:30.082:              Msg Type   :   CAPWAP_DISCOVERY_REQUEST
*spamApTask4: Feb 04 06:01:30.082:              Msg Length : 155
*spamApTask4: Feb 04 06:01:30.082:              Msg SeqNum : 0
*spamApTask4: Feb 04 06:01:30.082:   
*spamApTask4: Feb 04 06:01:30.082:       Type : CAPWAP_MSGELE_DISCOVERY_TYPE, Length 1
*spamApTask4: Feb 04 06:01:30.082:              Discovery Type : CAPWAP_DISCOVERY_TYPE_UNKNOWN
*spamApTask4: Feb 04 06:01:30.082:   
*spamApTask4: Feb 04 06:01:30.082:       Type : CAPWAP_MSGELE_WTP_BOARD_DATA, Length 62
*spamApTask4: Feb 04 06:01:30.083:              Vendor Identifier      : 0x00409600
*spamApTask4: Feb 04 06:01:30.083:              WTP_SERIAL_NUMBER : AIR-CAP2602E-I-K9
*spamApTask4: Feb 04 06:01:30.083:   
*spamApTask4: Feb 04 06:01:30.083:       Type : CAPWAP_MSGELE_WTP_DESCRIPTOR, Length 40
*spamApTask4: Feb 04 06:01:30.083:              Maximum Radios Supported  : 2
*spamApTask4: Feb 04 06:01:30.083:              Radios in Use             : 2
*spamApTask4: Feb 04 06:01:30.083:              Encryption Capabilities   : 0x00 0x01
*spamApTask4: Feb 04 06:01:30.083:   
*spamApTask4: Feb 04 06:01:30.083:       Type : CAPWAP_MSGELE_WTP_FRAME_TUNNEL, Length 1
*spamApTask4: Feb 04 06:01:30.083:              WTP Frame Tunnel Mode : NATIVE_FRAME_TUNNEL_MODE
*spamApTask4: Feb 04 06:01:30.083:   
*spamApTask4: Feb 04 06:01:30.083:       Type : CAPWAP_MSGELE_WTP_MAC_TYPE, Length 1
*spamApTask4: Feb 04 06:01:30.083:              WTP Mac Type  : SPLIT_MAC
*spamApTask4: Feb 04 06:01:30.083:   
*spamApTask4: Feb 04 06:01:30.083:       Type : CAPWAP_MSGELE_VENDOR_SPECIFIC_PAYLOAD, Length 10
*spamApTask4: Feb 04 06:01:30.083:              Vendor Identifier  : 0x00409600
*spamApTask4: Feb 04 06:01:30.083: 
        IE            :   UNKNOWN IE 207

*spamApTask4: Feb 04 06:01:30.083:      IE Length     :   4

*spamApTask4: Feb 04 06:01:30.083:      Decode routine not available, Printing Hex Dump

*spamApTask4: Feb 04 06:01:30.083: 00000000: 03 00 00 01                                       ....

*spamApTask4: Feb 04 06:01:30.083:   
*spamApTask4: Feb 04 06:01:30.083:       Type : CAPWAP_MSGELE_VENDOR_SPECIFIC_PAYLOAD, Length 12
*spamApTask4: Feb 04 06:01:30.083:              Vendor Identifier  : 0x00409600
*spamApTask4: Feb 04 06:01:30.083: 
        IE            :   RAD_NAME_PAYLOAD

*spamApTask4: Feb 04 06:01:30.083:      IE Length     :   6

*spamApTask4: Feb 04 06:01:30.083:      Rad  Name     :   
*spamApTask4: Feb 04 06:01:30.083: CEO_AP

*spamApTask4: Feb 04 06:01:30.083: <<<<  End of CAPWAP Packet  >>>>

*spamApTask4: Feb 04 06:01:30.083: dc:a5:f4:8c:ff:30 Discovery Request from 10.192.200.93:26711

*spamApTask4: Feb 04 06:01:30.083: dc:a5:f4:8c:ff:30 ApModel: AIR-CAP2602E-I-K9

*spamApTask4: Feb 04 06:01:30.083: dc:a5:f4:8c:ff:30 Join Priority Processing status = 0, Incoming Ap's Priority 1, MaxLrads = 200, joined Aps =0
*spamApTask4: Feb 04 06:01:30.083: apModel: AIR-CAP2602E-I-K9

*spamApTask4: Feb 04 06:01:30.083: apType = 26 apModel: AIR-CAP2602E-I-K9

*spamApTask4: Feb 04 06:01:30.083: apType: Ox1a bundleApImageVer: 8.0.110.0
*spamApTask4: Feb 04 06:01:30.083: version:8 release:0 maint:110 build:0
*spamApTask4: Feb 04 06:01:30.083: dc:a5:f4:8c:ff:30 Discovery Response sent to 10.192.200.93 port 26711

*spamApTask4: Feb 04 06:01:30.083: dc:a5:f4:8c:ff:30 Discovery Response sent to 10.192.200.93:26711

Please any help.

[shh5455]

Is the AP in flexconnect mode?  Does the AP have at least version 7.4 on it?  These are requirements.

[Ali mosbah Abdo]

Dear shh5455

in local mode because they was connected to wlc 2504, but if they joint i will change them to Flecconnect mode.

the vWLC is v 8.0.110

[shh5455 · Accepted solution]

You may need to put the AP in flexconnect mode before you move it.  Is the WLC 2504 at least 7.4?

[Ali mosbah Abdo]

dear

yes  the wlc  2504  is 8.0.110 but because its damaged i replaced it with  new vWLC v 8.0.110.

also i can not put the LAP in flexconnect until its joint.

[shh5455]

Can you pull the logs off of the AP when it's trying to join?

[Ali mosbah Abdo]

Thank you dear 

its joint now.

i just add command in the cWLC for flexconnect

BR