09-09-2016 01:37 AM - edited 07-05-2021 05:48 AM
Hello All,
We plan to use Port 1 and Port 2 to be connected on two different core switches. Attached images of the configuration of the two interface we created.
How can we know that the back-up port2 will take over if port1 is down. we are not using LAG
regards
09-09-2016 08:38 AM
This works fine as I have had customers whom wanted the same thing. To test, you basically unplug port one and wait for the AP's to join the controller again. With LAG, if one port goes down, there is a very small glitch and you usually will not notice it. The primary port and backup port, the AP's will have to discover the controller again. Test it out as its been a long time since I tried to test that design.
-Scott
*** Please rate helpful posts ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide