Cisco WLC 5508- Mobility tunnel creation

[networklearner1]

Hello All,

In our current wireless setup, we already have an Anchor WLC (5508) which is mapped to the Foreign WLC (5508).

I need to add a new Anchor WLC to the Foreign WLC. 

The Foreign WLC's are in HA pair. My question is, since the Foreign WLC's are in active-standby setup, do I need to just add the new Anchor IP in the Active foreign WLC or do I need to disable SSO and add the IP in both WLC's separately.

Please suggest.

Thank you.

[RoadRunner4k]

You should only add one IP ( the shared AP Mgmt IP this will be shared among the two devices)  use the MAC Address ( controller -->Redundancy --> Global Configuration ( Mobility Mac address)

[ammahend · Accepted solution]

yes, just need to add the new Anchor IP in the Active foreign WLC, No need to disable SSO. 

[networklearner1]

Thank you @RoadRunner4k @ammahend