07-29-2023 02:01 AM
on AireOS it was convenient to see if access point works in "full power" mode or medium/low power , e.g. https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-6/configuration-guide/b_cg76/b_cg76_chapter_01111010.pdf
But I have not found similar command on C9800 (Firmware Version 17.03.07)...
It there such possibility exists or it was removed and other indirect ways are only options for that ?!
Solved! Go to Solution.
07-29-2023 07:01 AM
I presume you're referring to PoE power rather than radio power? It still works pretty much the same as on AireOS:
9800#sh ap name <ap-name> config general | inc power|Power|PoE
PoE Pre-Standard Switch : Disabled
PoE Power Injector MAC Address : Disabled
Power Type/Mode : PoE/Full Power
AP power derate Capability : Disabled
9800#
07-29-2023 02:32 AM
- Checkout : show ap auto-rf dot11 24ghz <AP-name> | inc Power (e.g.)
M.
07-29-2023 07:01 AM
I presume you're referring to PoE power rather than radio power? It still works pretty much the same as on AireOS:
9800#sh ap name <ap-name> config general | inc power|Power|PoE
PoE Pre-Standard Switch : Disabled
PoE Power Injector MAC Address : Disabled
Power Type/Mode : PoE/Full Power
AP power derate Capability : Disabled
9800#
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide