cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
265
Views
10
Helpful
1
Replies
psbrowand
Beginner

Configure AP Location via CLI (9800)

I am looking for the command to configure the AP Location field via the CLI on a 9800 WLC. This is different than the AP Location command used to assign Tags to APs. The AP location field is present when you enter the configuration of an individual AP on the web interface under the name of the AP. You can change the field there, but I am looking for a way to do it via CLI. Is anyone able to help with the command I am looking for?

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Leo Laohoo
VIP Community Legend

The command must be entered in ENABLE MODE:  

ap name <AP NAME> location "AP LOCATION"

NOTE:  AP location is not stored in the WLC but stored in the AP itself.   

View solution in original post

1 REPLY 1
Leo Laohoo
VIP Community Legend

The command must be entered in ENABLE MODE:  

ap name <AP NAME> location "AP LOCATION"

NOTE:  AP location is not stored in the WLC but stored in the AP itself.   

View solution in original post

Create
Recognize Your Peers
Content for Community-Ad