cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2528
Views
10
Helpful
1
Replies

Configure AP Location via CLI (9800)

psbrowand
Level 1
Level 1

I am looking for the command to configure the AP Location field via the CLI on a 9800 WLC. This is different than the AP Location command used to assign Tags to APs. The AP location field is present when you enter the configuration of an individual AP on the web interface under the name of the AP. You can change the field there, but I am looking for a way to do it via CLI. Is anyone able to help with the command I am looking for?

 

 

1 Accepted Solution

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame

The command must be entered in ENABLE MODE:  

ap name <AP NAME> location "AP LOCATION"

NOTE:  AP location is not stored in the WLC but stored in the AP itself.   

View solution in original post

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

The command must be entered in ENABLE MODE:  

ap name <AP NAME> location "AP LOCATION"

NOTE:  AP location is not stored in the WLC but stored in the AP itself.   

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: