Configure IPSec between WLC and Server 2008 NPS?

[brendanhamilton]

I have been unable to get IPSec working between my WLC 5508 and a server 2008 NPS radius server.  Has anyone else has luck configuring this?  I have opened tickets with both Microsoft and Cisco, but so far have not been able to configure it properly. 

Thanks,

Brendan

[Stephen Rodriguez · Accepted solution]

IPSec should only be an option if the WLC has a crypto card installed.  IIRC, only the 4400 supported the crypto card, and it went EoS shortly after the airespace acquisition.

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

[brendanhamilton]

Thanks Stephen, you are right.  The 5500 series does not even support ipsec.  Unfortunately, the option is available in the console and I spent too much time trying to get it to work.

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70ovrv.html#wp1154082