10-05-2005 04:47 AM - edited 07-04-2021 11:11 AM
We had a Aironet which needs to installed on dark room but its status LED always blink. Could we turn off the LED by configure? As I knew this AP can be configured continuously blinking the status LED.
Solved! Go to Solution.
10-12-2005 07:32 PM
There is no way that I know of to turn off the leds. The only hidden command is one that allows you to blink them from the cli and change the duration of each but it will not stop them. Electrical tape over the leds is probably your only option.
10-09-2005 03:10 PM
Access the AP via a browser and go to System Software -> System Configuration
There should be an option there for Blink the Access Point LEDs
10-12-2005 07:19 PM
Thank, that is for LED blink.But, we need to turn off the "Status LED".
10-12-2005 07:32 PM
There is no way that I know of to turn off the leds. The only hidden command is one that allows you to blink them from the cli and change the duration of each but it will not stop them. Electrical tape over the leds is probably your only option.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide