Wireless

Hello,I'm in the process of installing a WLC but am having trouble with the internal DHCP server, I am able to associate but am not assigned an IP address, this is the configuration : Client interface :Interface Name.....................................

hello,at the moment i have two 4404-100 controllers. in the backbone we have two 4500 switches. the two 4500's are connected via an 4 gbit channel. for l3 redundancy weuse hsrp. the controllers have the following ip configuration:controller 1: vlan 2...

Hi NetPro,does anyone knows how / what command use for AP setting. which means i want this user only associate with specific AP only. i am using Cisco Aironet 1200 series.your reply will be higly appreciated.regards,Jackal

I have a AIR-LAP1242AG-A-K9 that I need to setup using Autonomous Mode. From what I understand I need software to do this but I didn't get anything with the device. I see the AP gets an IP address but when I try to access it IE does not find it.

Hi,I have an AP1220 configured connected to trunk port on a 2980 switch. On the AP i have it setup like this on the Dot1Radio0 Interface:interface Dot11Radio0 no ip address no ip route-cache ! ssid Internal vlan 7 authentication open guest-mode !But ...

I have two BR1310Gs and two AP1231Gs.The 4 pcs I'm using for testing purposes are all running IE6 (various versions) and can all connect to the APs and funtionality on web interface is fine.However the BR1310Gs are causing problems. On three of the p...

I have 1300 bridges in station root and non-root mode and all the vlans can communicate across it with address assigned. But when a new unit (pc or phone) is attached.....the DHCP broadcast does not get sent across the wireless link to the DHCP serve...

I am managing a deployment of 500+ access points using WISMs and WCS (both v4.2). We have many SSIDs but need to be able to restrict the availability of certain SSIDs in parts of the campus. How is this best achieved?

i've just upgraded our WLSE to WCS using CDs 80-8572-01 and 80-8568-01 following the Cisco documentation. the upgrade seemed to have gone well but i can't login throu the WCS web gui. i get the error:-Error(s): You must correct the following error(s)...

I always have this problem when I console to the AP1200 to start initial configuration. I see it boot up on the terminal, but when i press enter to get started, nothing comes up on th eterminal.So I usually connect it to the network, allowing it to o...

I have a WLAN on a VLAN. Testing with open security till I get DHCP working. Using external DHCP server. The DHCP server exists on a different subnet then the scope it gives to clients. I have an interface defined on the VLAN and associated with the ...

Hello,i have an AP1100 (12.3.8JEB1) , several IP Phones 7920 .All is working but i would like to limit tne number of simultaneous calls to 3 for example.There is a function called CAC in the AP with bandwidth limitation (max channel percentage).When ...