CW9164 AP Configuration

[pavansharma]

Anyone can tell me what is the default username & password of cisco cw9164 access point is CLI

Kindly let us know also how to configure it.

[RoadRunner4k · Accepted solution]

should default be Cisco/Cisco

[pavansharma]

I tried it many times but not  succeed.

[RoadRunner4k]

Im assuming its running in EWC mode-

Cisco Embedded Wireless Controller on Catalyst Access Points Configuration Guide, IOS XE Dublin 17.12.x - Overview of Cisco Embedded Wireless Controller on Catalyst Access Points [Cisco Embedded Wireless Controller on Catalyst Access Points] - Cisco

[pavansharma]

I want to configure it like c9115 AP.

[jagan.chowdam]

Cisco 9164 doesn't support EWC I believe. 

The following Catalyst APs are only supported as EWC.
Cisco Catalyst APs: 9130 (I/E), 9124 (I/D/E), 9120 (I/E/P), 9117, 9115 (I/E), 9105 (I/W)

Ref: https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html#c9800-embed-ctr-ap_support

Have you tried username and password admin/admin. 

First make sure it is a Cisco Catalyst AP (DNA Persona) and not Meraki persona. To confirm the AP is not in Meraki mode, HTTPS to the IP address of it.

If you get a splash page then use the serial number as username and no password to login to Meraki AP. 

Jagan Chowdam

/**Please rate helpful responses**/

[pavansharma]

I have tried admin/admin also but not succeed

[kutumela]

Hi 

Did you do factory reset on the device first and restarted afterwards ?

[pavansharma]

Yes did the same but nothing happened and still not able to login.

[Haydn Andrews]

Admin/Cisco

[pavansharma · Accepted solution]

Now, Problem is resolved. Reset time is >30 Sec then I am able to login with Cisco/Cisco.