CW9166I-Dual Band Operating Mode

[madhurimuppalla]

Hi ,

->How can I configure CW9166 Access point into dual-band mode with specific bands active and deactivated, such as having the 2.4GHz and 5GHz bands active while keeping the 6GHz band deactivated, or alternatively, configuring it with the 2.4GHz and 6GHz bands active and the 5GHz band deactivated?
->Is it possible to reconfigure the dual-band operating mode of the CW9166 Access Point with less than 10 seconds of service interruption? If so, could you please explain how this can be achieved?

[balaji.bandi]

how is these managing using WLC? then you can look at the WLC to make this settings.

Make sure you Profile them based on the requirement to disable and enable features on the given AP devices.

->Is it possible to reconfigure the dual-band operating mode of the CW9166 Access Point with less than 10 seconds of service interruption? If so, could you please explain how this can be achieved?

check below thread :

https://community.cisco.com/t5/wireless/9800-disable-specific-interface-2-4-or-5-ghz-for-set-of-aps/td-p/4413004

WLC config guide :

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-3/config-guide/b_wl_17_3_cg/m_cisco_ap_tri-radio.html