cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1072
Views
0
Helpful
4
Replies

Does anyone know what the "Provision Failure: MEDIATION-5, Lrad! errors are in WCS

tdennehy
Level 1
Level 1

Does anyone know what the "Provision Failure: MEDIATION-5, Lrad! errors are in WCS? 

I get this when pushing an AP template to six new 3502i series access points.  The error reads like this:

*** Apply Result for AP 'NameOfAPhere(C0:FF:EE:C0:F:EE)' ***

**AP Parameters**

Provision Failure: MEDIATION-5, Lrad!C0:FF:EE:C0:F:EE,secondaryMwar,No access

MAC address has been changes to protect the names of the innocent...

The rest of the template appears to push.  The 802.11a/n and 802.11b/g/n parameters show "success".

Anyone have the magic decoder ring for what these messages are referring to so that I can go fix the issue?

Thanks in adavance!

1 Accepted Solution

Accepted Solutions

Salil Prabhu
Cisco Employee
Cisco Employee

Hi,

Two things :

1- Can you refresh configs from WLC to WCS and then give it a try ?

2- Is WCS using the right read-write community string for this WLC ?

   (Since we see a "No Access" message in the error)

Thanks..Salil

View solution in original post

4 Replies 4

Salil Prabhu
Cisco Employee
Cisco Employee

Hi,

Two things :

1- Can you refresh configs from WLC to WCS and then give it a try ?

2- Is WCS using the right read-write community string for this WLC ?

   (Since we see a "No Access" message in the error)

Thanks..Salil

Thanks for the help.

Turns out it was an SNMP misconfig in the controller!

Glad it worked out.. Since your issue is resolved would you mark it to "answered" so others can benefit when they search the database.

Thanks..Salil

Review Cisco Networking for a $25 gift card