Double Broadcast SSID

[Reedho]

I just configured AP 1830 via firmware mobility express via the GUI and it worked. But after restarting the system, the device still broadcasts the default SSID "CiscoAirProvision" and the SSID that I made, so also I can't get into AP management.

How can I get rid of the Default SSID so it does not appear and can enter the GUI with the management that I have made?

I use AIR-AP1830-K9-8-8-125-0 Firmware

[Sandeep Choudhary]

reset it completely and start from scrach again.

[Reedho]

I have tried to do this. but the result still can't (same thing).

[patoberli]

Do you save the configuration before reloading it after the initial wizard?

[Reedho]

No. This is a new device, and I did a conversion from Firmware lightweight (Capwap) to Mobility Express.

for successful conversion results until I do the configuration. but after restarting, there are two SSIDs, and I can't get into device management.

[patoberli]

This is weird.
Normally (after a reset) you login to the CiscoAirProvision SSID, do the basic configuration, save and reboot. After the reboot, the old SSID should not anymore visible and your new one should be there.
Can you check with a second client if that Air... SSID is indeed broadcasted? Maybe it's a client driver fault.

[Sandeep Choudhary]

if possible, change the software version on MObility express AP and then try again.