ERROR!!! Command is disabled.

[brock0150]

I have a lwapp 1130 here and it's no longer associated with the controller.  I issued the clear lwapp private-config, it went through and cleared the config.  Now when I try to issue the lwapp commands to set the ip and such i get ERROR!!! Command is disabled. I read that this means the static configuration is locked, but it did not say how to "unlock" it.  Any ideas or suggestions on how to get this re-enabled.

This information has been added in the following Document - https://supportforums.cisco.com/docs/DOC-21897

[Fraser Reid]

Thank you all for your help in this - I will try everything I can until this works - but to note - there is only 1 LAP IOS and 1 Aut IOS on the device.

Fraser Reid

--

Fraser Reid

GMX DSL Doppel-Flat ab 19,99 €/mtl.! Jetzt auch mit

gratis Notebook-Flat! http://portal.gmx.net/de/go/dsl

[Vinay Sharma]

Check this Document

ERROR!!! Command is disabled - https://supportforums.cisco.com/docs/DOC-21897

Thanks.