11-17-2015 04:44 AM - edited 07-05-2021 04:14 AM
Hi Experts,
One of our AP 1242AG autonomous model giving the error continiously "MDIO_wait: PHY error. port 0" . Hence we have done the reset , formatted the flash , downgraded the image to c1240-k9w7-tar.124-10b.JDA3.tar .
But still we are getting the same message.Whereas Fastethernet port 0 connectivity is fine without any issue . Any idea on this.
Thanks ,
Tamil
11-17-2015 05:11 AM
Hi Tamil,
Can you paste the complete logs from AP(Console access).
Regards
Dont forget to rate helpful posts
11-17-2015 05:53 AM
11-17-2015 06:18 AM
Raise a TAC case and clarify with them.(You will need a valid CCO contract to raise a case)
http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide