cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
814
Views
10
Helpful
3
Replies

FlexConnect and 802.1q tagging

iores
Level 3
Level 3

Hi,

when I look in the mac address table, I don't see the VLAN for a particular WLAN under the trunk port of the switch which is connected to FlexConnect AP. If AP performs tagging, why I don't see it in the mac address table?

3 Replies 3

marce1000
Hall of Fame
Hall of Fame

 

 - Which command did you try and or can you test with : sh mac address-table int g0/4 (e.g. -> the latter being the port where the access point would then be connected ) ?

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

@marce1000 

 

sh mac address-table vlan X

- Try the interface version according to my example.

M.


-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card