- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 06:24 AM
Hi I have a 3504 & 5500 WLC,
I have guset Wifi all set up. However, I am looking to set up a splash page for the Guest Wifi. I cannot find it anywhere?
Our Guest authenticate via ISE
Any help much appreciated
Solved! Go to Solution.
- Labels:
-
Wireless LAN Controller
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 09:49 PM
once the guest user session is established, it will not disconnect if you make changes to customize the portal, next time when the users will connect and get redirected, they will see the updated customized page.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 02:04 PM
Not 100% sure what you currently have setup. Do you already have a captive portal on ISE and you can’t find where the portal is to edit it? Or you need to configure one?
Few guides on configuring guest portals (Hotspot, Self Registered, Sponsored, Authenticated) below that should help point you in the direction your after
https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/115732-central-web-auth-00.html
https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/216330-ise-self-registered-guest-portal-configu.html
https://community.cisco.com/t5/security-knowledge-base/ise-guest-amp-web-authentication/ta-p/3657224
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 03:18 PM
However if I change images in the guest portal whilst users are connected
to guest WiFi, will they lose connection?
Thanks in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 03:39 PM
No current users wont get affected. Portal will update when you hit save in ISE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 03:39 PM
Hi there,
To clarify, I mean change anything in the "Portal Page Customisation" section of ISE. This is where Wifi Guest Users get authenticated
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2022 09:49 PM
once the guest user session is established, it will not disconnect if you make changes to customize the portal, next time when the users will connect and get redirected, they will see the updated customized page.
